1, Reasons for seal damage
The sealing components of submersible pumps are mainly achieved through two methods: mechanical seals and packing seals. Whether it is mechanical seal or packing seal, the reasons for seal damage are quite complex, mainly including the following points:
1. Poor operating environment: Mud, chemically corrosive liquids, and other environments can easily cause seal damage.
2. Improper use: Long term overload work, frequent start stop, or improper operation direction can all cause damage to the seals.
3. Quality issues with the sealing components themselves.
2, Repair method
When the seal of the submersible pump is damaged, the following methods need to be used for repair:
1. Replace the seal. Replace the damaged seal with a new seal of the same type and specification. When replacing, pay attention to the installation position and correct usage of the seal to avoid damaging it again.
2. Repair the damaged seal. Suitable for situations where the sealing part is not obvious or the sealing component specifications are special and difficult to replace. Sealing glue or sealing film can be used for repair, but this method is only temporary. In the long run, it is more secure to replace the entire seal.
3. Upgrade the sealing components. According to the usage environment and pump body requirements, selecting higher quality seals for upgrading can improve the sealing performance and service life of submersible pumps.
3, Preventive measures
In addition to timely repairing seal damage, the following points should also be noted in daily use to extend the service life of submersible pumps:
1. The usage environment should be kept as clean as possible to avoid damage to the pump body caused by mud, chemical liquids, etc.
2. When operating, it is necessary to use it correctly according to the instructions to avoid frequent starting and stopping, long-term overload work, and other situations.
3. Regularly check the working condition of the pump body seals, and replace or repair them promptly if any abnormalities are found.
4. When the service life expires or the performance decreases, the seals should be replaced in a timely manner to avoid more serious damage.
In short, the damage to the seals of submersible pumps is a serious problem that needs to be repaired in a timely manner to avoid causing greater losses. At the same time, preventive measures should be strengthened to extend the service life of submersible pumps.
